ACME Wireless On-Ear Headphones with Microphone

You will enjoy it then, because this device enables you to listen to music for up to 10 hours straight!

It takes only 2,5 hours for the device to get fully charged. The process is very simple – connect your device to the source of energy using a micro-USB cable and wait for the red LED light to switch off and for the blue LED light to switch on – that’s when the device is fully charged and ready to be used!

It’s very simple. Turn on your headphones by pressing on the power button for 10 seconds. Once both blue and red LED lights start quickly flashing, it’s an indicator that the headphones are ready to be paired. The next step is to turn on “Bluetooth” on your smartphone and select BH60 from the list of available options. Once the blue LED light on your headphones stops flashing and becomes constant, it’s an indicator that your device has been successfully paired with your smartphone. * Please note that if the headphones have lost your smartphone’s “Bluetooth” connection and haven’t been used for 5 minutes, they will automatically switch off (great way to save the battery, right?)

You bet they do! Enjoy talking over the phone hands-free!

It’s very straightforward – simply touch the volume toggle up or down if you want to adjust the sound volume. The device will let out a precaution signal once the highest allowed volume has been reached.

First of all, in order to switch on or off the device, you simply press and hold the button for 5 seconds. Next, in order to turn on or off the music, simply push the button once. The same applies if someone is calling you in the middle of your listening session – to answer or end the call, simply press the button once. However, if you want to reject the phone call without picking it up, press and hold the button for 2 seconds. Finally, if you want to call back the last person you rang:  press the button twice.

You can listen to your music while being up to 10 meters away from your smartphone.

Don’t panic – simply charge your headphones to the fullest and check if the LED light is glowing.

Most importantly - don’t worry. On your device go to “Bluetooth” settings, select BH60 from the list of available devices, and click on ‘Forget’. Now, your device has ‘forgotten’ that it was paired with your headphones, so you can do the pairing again. Your headphones might also be connected to another nearby device, in which case you would need to disconnect them from that device.

No, it’s not – simply put your finger either a bit higher or a bit lower when toutching the toggle. Since the sensor area is quite small, it can be a bit tricky to find its sweet spot.